Verification According to the Theory of Limit States
When running the verification analysis according to the theory of limit states, it is possible to introduce the required values of design coefficients in the "Piles" tab.
The program performs verification of the compression pile as:
where: | Rc | - | pile compressive resistance |
Rb | - | pile base resistance | |
Rs | - | pile shaft resistance | |
γb | - | partial factor on pile base resistance | |
γs | - | partial factor on pile shaft resistance | |
Vd | - | extreme vertical load acting on a pile | |
Wp | - | pile self-weight |
For tension pile the following verification applies:
where: | Rsdt | - | pile tensile resistance |
Rs | - | pile shaft resistance | |
γst | - | partial factor on tensile pile shaft resistance | |
Vd | - | extreme vertical load acting on a pile | |
Wp | - | pile self-weight |